Gas Plumber Hampton Park

Gas work needs a licensed gasfitter

In Victoria, gas work must be done by a gasfitter licensed by the Victorian Building Authority. It is not something a handyman, appliance retailer's general installer or homeowner can legally do. Licensed gasfitters test every connection for leaks, set appliances to the correct pressure, check ventilation and flueing, and issue a compliance certificate for regulated work.

Gas leaks

If you smell gas, turn the gas off at the meter, open doors and windows, avoid switches and naked flames and call us from outside the house. Leaks often come from old flexible appliance hoses, loose bayonet fittings, corroded pipe, or a fault in an appliance. We find the leak using pressure testing and leak detection fluid or electronic detectors, repair or replace the faulty section and test the whole system before turning it back on.

Cooktops, ovens and kitchen renovations

Changing a cooktop, fitting a new freestanding oven or renovating a kitchen? We disconnect old appliances, run or alter the gas line, connect the new appliance with the right fittings, test for leaks and check the burners light and burn correctly. We work with your kitchen installer so the gas point is in the right place before benchtops go in.

Heaters and carbon monoxide safety

Many Hampton Park homes built in the 1970s and 1980s still have gas wall furnaces, space heaters or older ducted systems. Poorly maintained or flued gas heaters can leak carbon monoxide into the home, which you cannot see or smell. We service gas heaters, clean burners, test for flue spillage and carbon monoxide and advise on whether an older heater is safe to keep using. Servicing every two years is recommended.

Hot water and other appliances

We install and repair gas hot water units, both storage and continuous-flow, and connect outdoor barbecues, pizza ovens, patio heaters and gas bayonets. If adding an appliance means the meter or pipe is too small, we tell you and arrange the upgrade with the gas distributor.

New gas lines and disconnections

We run new gas pipe for extensions and renovations, move gas points, and safely cap or disconnect lines when appliances are removed or homes go all-electric. Disconnections are done properly, with the line capped and tested, and the paperwork to match.

Hampton Park homes and gas

Older homes in the suburb often have gas pipe that has been extended over the years by different people. Joints can be tired, and a few homes have galvanised gas pipe that is starting to corrode. Newer estates usually have copper or approved multilayer pipe, but continuous-flow units on these homes sometimes need a larger gas supply than the original installation provided. We check the whole system when we work on it.

Signs your gas appliances need attention

Watch for yellow or orange flames instead of a crisp blue, soot marks above a heater or cooktop, a pilot light that keeps going out, a smell of gas near an appliance or the meter, a hissing sound, or a gas bill that has jumped without explanation. Any of these is a reason to call a licensed gasfitter rather than wait.

Gas meters and pressure

The gas meter and regulator belong to the gas distributor, but the pipework from the meter into the house is yours. When a continuous-flow unit, a large cooktop or a ducted heater struggles, the cause can be pipework that is too small for the total load. We measure the pressure at the appliance under full load and recommend a fix, which may be a larger pipe or a meter upgrade arranged with the distributor.

Going all-electric

More Hampton Park households are moving from gas to electric hot water, heating and cooking. When you remove your last gas appliance, the gas line needs to be properly capped and the meter can be removed by the distributor. We disconnect appliances safely, cap and test the line and help you plan the changeover so you are never without hot water.

Compliance certificates

For regulated gas work, such as installing an appliance or altering gas pipe, we lodge a compliance certificate with the Victorian Building Authority and give you a copy. It confirms the work was done by a licensed gasfitter to the standards. Keep it with your home records, as insurers and buyers may ask for it.

Outdoor gas points

A bayonet fitting on the deck or patio lets you plug in a barbecue or heater without changing gas bottles. We install outdoor points in safe locations with the correct fittings and test the connection.

Older galvanised gas pipe

Some homes built in the 1970s still have galvanised steel gas pipe, especially where it runs underground from the meter. Over decades it can corrode and develop slow leaks that you may only notice as a faint smell outside or a higher bill. We pressure-test the system to check, and replace corroded sections with approved pipe.

Gas cooktop changeovers

Swapping an old cooktop for a new one is one of our most common gas jobs. New cooktops may have different connection positions or need a regulator, and the bench cut-out may need adjusting. We check this before the day so the changeover goes smoothly, then test each burner for correct flame and ignition.

Commercial gas work

Cafes, takeaway shops and small workshops around Hampton Park and Dandenong South rely on gas for cooking, heating and hot water. We service and repair commercial appliances, install new equipment and check that ventilation and gas supply are adequate for the load.

Ducted heating and wall furnaces

Ducted gas heaters in roof spaces and wall furnaces in living rooms are common in Hampton Park homes of the 1980s and 1990s. We service the gas side, clean burners, check heat exchangers for cracks where accessible and test for carbon monoxide. If a heat exchanger is cracked, the heater must not be used until it is repaired or replaced, because combustion gases can enter the air you breathe.

Barbecue and outdoor kitchen connections

Outdoor kitchens with built-in barbecues, side burners or pizza ovens need gas run safely under paving or along walls, with isolation valves you can reach. We plan the route, install the pipe and test it before the paving goes down.

Gas leak testing

A full gas pressure test checks the whole installation, from the meter to every appliance. We isolate the system, apply test pressure and watch the gauge. If it drops, we track the leak down joint by joint. It is a sensible check when you buy an older home or before connecting a new appliance to old pipe.

Every gas job is tested before we leave.

Hampton Park soil and pipes

Hampton Park sits on heavy grey clay over sandier ground towards Lyndhurst, and that clay swells in a wet winter and shrinks and cracks in a dry summer. The older homes west of Hallam Road were mostly connected with earthenware sewer pipe in short lengths, and every joint is a place for roots to get in once the ground moves. Galvanised steel water pipe from the same era rusts from the inside, narrowing the bore and eventually leaking. On the newer estates, PVC drains are tougher, but trenches that were not compacted properly can settle and leave dips that hold grease and paper. We use a drain camera and pressure testing to see what is actually happening rather than guessing.

How we approach the job

From your call to the finished job